Kvaser BlackBird Getting Started Guide
45 (47)
Press OK to apply the settings.
If the device is reachable when you press the Search button but missing from the
scan list until you enter the unit manually, then you probably have a firewall in the
computer that is blocking some of the traffic.
9.13
Service status indications
CONNECTION_UP
means the service has established a connection to the device.
STANDBY
means the device is in the list but the service isn’t trying to use it.
UNWILLING
means some type of connection problem. Maybe the device is in use
already, maybe it is being configured via USB, or maybe the connection
password is wrong.
9.14
Disconnect USB cable
The service will not be able to connect to the Kvaser BlackBird under any one of
the following conditions:
1. The USB cable is connected.
2. Someone is configuring the device.
3. Another service is already connected to the device.
9.15
Scanning will not detect devices on other IP networks
The scanning process will only detect Kvaser BlackBirds on the local network. If
the Kvaser BlackBird you are trying to use is behind a router of any kind, you must
add it manually to the list.
9.16
Restart the service
This should not normally be necessary, but as a troubleshooting measure you can
stop the service and start it again. Use the Tools tab in Kvaser Hardware, or use
Control Panel -> Administrative Tools -> Services.
9.17
Check your firewall
The default port number used by the Kvaser BlackBird is 11416. This port is used
for both UDP and TCP and should be open for both incoming and outgoing traffic
Kvaser AB, Mölndal, Sweden — www.kvaser.com
