Kval Edge-SS, Руководство по эксплуатации

Страница: 86 / 152

About the Edge-SS Process
KVAL Operation Manual
3-2
About the Edge-SS Process
Ensure the start-up process has been completed ( See page 3-8 ), that the machine has been
Homed
,
doors are loaded to be processed, and the area is clear and safe to start production.
1.
If needed, set the job parameters from the
Edge-SS
Main Screen
. See “About the Edge-SS Interface
Screens” on page 3-14 for instructions.
2.
Move the door into the
Edge-SS.
7.
If the machine is set on
Auto Clamp
, the clamps
will automatically unclamp. If not set to Auto
Clamp, press the
Door Clamp Foot Pedal
to
unclamp.
8.
Follow any other process instructions on the screen
and position door accordingly.
9.
After all cuts are completed, press the
Blue Door
Finished Button
to feed the completed door into the
next stage.
3.
Push the
Door Stop
Foot Pedal
to pop-
up the stops.
4.
Position the door
against the stop and
fence according to the
Operator’s Screen
5.
After the door is set,
press the
Door
Clamp Foot Pedal
to
secure the
door.(
Note: If not clamped correctly, press the
clamp pedal again, re-set and press the pedal
again.)
6.
Press the
Start Sequence Button
to
begin the cutting process.
Note: The indicator lights will follow
the per-programmed cut. If needed
use the
Edge Toggle Button to
manually process.
Actions
Pull door in
from the previ-
ous machine
Roll the door
into the
machine
Actions
Door Stops
Position Door
Clamp Door
Start Sequence
Process Door
Check Screen
Complete Cuts
Actions
Move Door Out.
A
uto
Feed
Press Feed Out
Feeder will
move door out