Kval Commander III, Руководство по эксплуатации

Страница: 88 / 168

Powering Operations for the Commander III
3-7
Commander III Operation Manual
Home the Commander III
The Commander III must go through a homing routine before any operations are performed. The
homing routine sets a zero reference from which the Commander III measures its movement and
cutting process.
If power is lost or the Commander III is re-set, the homing routine must be performed again to
reset the zero reference.
Press the
Home
button on the
Main Screen
touch screen.
How to Power Down the Commander III
1.
Select the
Stop
button if machine is running.
2.
Right click the KVAL Icon at the bottom of the page select
Exit
from the drop down menu.
Note:
Make sure Windows is shutdown completely before
turning off the machine. Hard drive or data may be
damaged if not turned off in this order.
3.
Switch the green
CONTROL TRANSFORMER
switch to the
OFF position.
4.
KVAL also recommends that you turn the disconnect
switch on the electrical cabinet to OFF; this helps reduce
possible damage resulting from power surges from electri-
cal storms.
1.
The machine will move to the home position at the in-feed
end of the machine.
2.
The machine will then move to its neutral position
3.
The Commander III is now ready for work.
1
2
3
4