Kval 990FX, Руководство по эксплуатации

Страница: 52 / 96

About the Setup Screen
KVAL 990-FX Operation Manual
2-22
Enter a Positive or Negative Number
Determine when to enter a positive of negative number by using the
Left Hand Rule
. Use the cut
on the door as a reference. Hold out the left hand with the first finger pointed at the cut on the
door, second finger and thumb at right angle to each other. The first finger represents the positive
direction of the ‘Z” axis, the thumb represents the positive direction of the ‘Y” axis, then second
finger represents the positive the direction of the ‘X’ axis.
Entering Calibration Offsets
Below are general instructions to perform a calibration.
1.
Check for deviations in the expected machining and actual machining. Measure the
offset from the expected result. Use this number to enter into the offset box under
the inaccurate parameter.
Note: Maximum offset is 0.50 inches. If more than 0.50 inches of adjustment is needed, there is a high
probability that another issue may be causing a problem. If issues can not be resolved, contact the
KVAL Service Center KVAL Inc. (1-800-553-5825).
See “Getting Help from KVAL” on
page 1-14.
5.
Run a test door again to verify the offset correction was successful.
6.
Keep running a test door and adjusting the offset until satisfied with the result
Y -
Y-
X Axis Positive
movement
Z Axis Positive
movement
Y Axis Posi
-
tive movement
Z -
X -
Y +
Z +
X +
Lock Plate Cut
Facing the Rear Section
2.
Enter the offset positive or negative number in
the box next to the
+/- Offset
button
3.
The
Base
display box keeps a running total of
data entered to help keep track of the changes.
4.
The
Combine with Base
button merges the offset number to the base to adjust the
servo.