Kval 990-H, Руководство по эксплуатации

Страница: 67 / 88

Additional Functions Group
Skip Hinge 1-3:
Select to Skip the hinge router and drill
functions any hinge.
Jamb Knockout:
Test Mode:
Select to toggle the Test Mode on or off.
Test Mode runs the hinge cycle, but does not extend the
tools. This is primarily used to verify a new template is correct and the hinge carriage
will not bump into the H-Block or other assemblies.
Width Adjust Group
Width Adjust:
•
Open:
Press and
hold
the
Open
button to open the
width adjust carriage. To stop the carriage, release
the button. The carriage will also stop if the posi-
tive travel limit eye is activated.
•
Close:
Press and
hold
the
Close
button to close the
width adjust carriage. To stop the carriage, release
the button. The carriage will also stop if the negative travel limit eye is activated.
Door:
•
Stop:
Press the
Stop
button to extend or retract the appropriate door stop.
•
Clamp:
Press
Clamp
to activate the cylinders that clamp the door.
Feed:
•
Reverse:
Press and hold the
Reverse
button reverse the feed of the door. To stop
the feed, release the button.
•
Forward:
Press and hold the
Forward
button to move the door feed forward. To
stop the feed, release the button.
•
Normal Speed:
Press and hold the
Normal Speed
button to slow speed. To return
to previous speed, release the button.
Toggle Buttons:
• The buttons to the right toggle auto functions on or off. For descriptions of these
buttons, see “Auto Enable and Disable Buttons” on page 2-35 .
Manual Operation
KVAL 990-H Operation Manual
2-38