KV2 Audio KVV 987 454, Руководство пользователя

Страница: 7 / 24

5
SL3000D · G
etting S
tar
ted
SL3000D · Getting Started
AC Requirements
Two PowerCon cables are provided to connect the SL3000D Amplifier to a suitable AC power supplies. Each cable powers
each separate amplifier channel for sufficient current delivery.
THE SL3000D REQUIRES A GROUND CONNECTION. ALWAYS USE A GROUNDED OUTLET AND PLUG.
The PowerCon is a connector without breaking capacity, i.e. the PowerCon should not be connected or disconnected under
load or while it is live. Always isolate your AC supply before disconnecting the PowerCon connector.
The SL3000D amplifier operates in either 115V, 230V or 250V modes. Although pre-configured at the factory, the unit's
operating voltage mode can be changed in the field. Amplifier power plug must remain readily operable.
Your amplifier will be supplied preset to the voltage used in your area. The table below provides typical current draw figures
for the SL3000D Amplifier.
The receptacle must be connected to a fuse or circuit breaker. Connection to any other type of receptacle poses a shock
hazard and may violate local electrical codes.
Do not allow water or any foreign object to get inside the amplifier. Do not put objects containing liquid on or near tne unit.
To reduce the risk of overheating the amplifier, avoid exposing it to direct sunlight.
Do not install the unit near heat-emitting appliances, such as a room heater or stove. This amplifier contains potentially
hazardous voltages. Do not attempt to disassemble the unit. The unit contains no user serviceable parts, repairs should be
performed only by factory trained service personnel.
AC Input Current draw with
amplifier running at Average
Power (Each Channel)
Current draw with
amplifier running at
Peak Power (Each Channel)
250V 3.2A 5A
230V 3.5A 5.4A
115V 7A 11A
Current draw of SL3000D Amplifier