Routing and Installing System Cables
Manual Part Number:
006-1219-00 Rev. 0
4–9
Digital Eyewitness
®
HD
In-Car Video System
10. Install a butt connector on the end of the orange wire.
11. Use the other half of the butt connector to connect the orange power tamer wire to the red
and white power wires from the Eyewitness
®
HD power cable.
12. Install the supplied ring terminal on the end of the black wire on the power tamer.
13. Locate a good chassis ground that is as close as possible to the negative terminal of the
battery.
14. Remove the bolt for the chassis ground.
15. If other cables are attached to this chassis ground, install the Eyewitness
®
HD ground
(the green and black wires) under the others.
16. Reinstall the chassis ground bolt and tighten it.
Figure 4-9.
Chassis Ground Connection (Charger Shown)
17. Once all connections are made and the system is ready to be powered up, install the fuse
into the in-line fuse holder in the main power pigtail harness.
18. Test the function of the system, once all connections have been made at the DVR.
19. Secure the power tamer in its final mounting location. This may be done using screws, or
using a hook and loop product like Velcro®.
20. Organize the wiring and secure it with zip ties.
21. Reinstall any of the interior trim panels that were removed to facilitate the installation of
the power tamer.
