Küschall® K-Series
1.
Loosen the bolts
A
on both clamp sets.
2.
Rotate the axle tube
B
to set the correct position.
3.
Retighten the bolts on both sides.
This setting must be carried out on a horizontal
surface. The track of the rear wheels is correct if the
distance between the rear wheels is the same at the
front and the back (x=y) – measured at the height
of the centre of the axle.
6.7.2 Adjusting the removable axle
Open-end spanner (19) / Straddle spanner (11)
■■□
1.
Remove the rear wheel.
2.
Hold the end of the removable axle
B
using the straddle
spanner.
3.
Adjust the length L of the removable axle by turning the
nut
A
. The length is correctly adjusted if the removable
axle engages correctly when installing the wheel and
the wheel has just minimal clearance.
The wheels must be exchanged (left to right side
and vice versa) after adjusting both removable axles.
The adjustment must now be checked or carried out
again to ensure the wheels can be switched.
6.7.3 Installing/adjusting the rear wheel extension
Allen key (3 mm, 4 mm, 5 mm) / Socket spanner (8 mm)
■■□
1.
Remove both rear wheels.
2.
Remove bolt and nut
A
on both sides and remove the
axle holder
B
with the axle from the frame
C
.
3.
Remove the bolt
D
and bolt and nut
E
on both sides
and remove the axle holder from the axle.
4.
Install the axle locking ring
F
to the required hole in
the rear wheel extension
H
using bolts and washers
G
.
Here, do not yet tighten the screws. Slide the two rear
wheel extensions onto the axle.
If a Vario-Ax is to be installed, another
appropriate locking ring must be used.
5.
Install the rear wheel extension to both sides of the
frame using the bolts and nut
A
.
6.
Ensure that the rear wheels are parallel, see
Ensuring the rear wheels are parallel, page 33
.
7.
Tighten the screw
I
on the axle locking ring on both
sides to fix the axle.
8.
Tighten the bolts with washers
G
on both sides.
A
= 13 Nm
G
= 7 Nm
I
= 7 Nm
6.7.4 Changing the wheel camber / Installing and adjusting an axle
The following table describes the axle length [mm] in relationship to the seat width (SW) [mm] and the camber angle. The
axle length varies depending on whether a clothes-guard or a mudguard/armrest mounted. The axle length is defined as
the length of the axle tube (without axle sleeves).
34
1659339-A
Содержание K-SERIES
Страница 11: ...Instructions 6 Instructions 1659339 A 11 ...
Страница 42: ...Küschall K Series Front side Rear side 42 1659339 A ...
Страница 43: ...Notes ...
