6.5.2 Installing the tubular armrest
WARNING!
Risk of injuries due to incorrect installation
If the tubular armrest option is to be installed, the seat module must be cut off depending on the configuration
of the wheelchair.
– The tubular armrest must only be installed by Invacare shop assembly. Therefore, contact Invacare customer
service.
Adjusting the height
Allen key (4 mm) / Socket spanner (8 mm)
■■□
1.
Remove bolt, washer and nut
B
.
2.
Reposition the round nut
A
in the armrest tube.
3.
Reinsert the bolt into the round nut through the
appropriate hole in the tube and tighten with washer
and nut
B
.
4.
Place the armrest in the holder.
B
= 7 Nm
6.5.3 Installing/adjusting the siderest
The rear seat-to-floor height (RSTF) must be at least 420 mm for installing siderests.
Allen key (4 mm, 5 mm) / Phillips screw driver (2 mm)
■■□
1.
Install the holder
B
to the seat module using the screw
connections
A
and bracket
C
.
2.
Slightly loosen the grub screw
D
on the adjustment
plate
E
and adjust the siderest to the required height.
3.
Retighten the grub screw.
4.
Carry out the same setting on both sides.
5.
Tighten or loosen the screws
F
to adjust how easy the
mudguard can be moved out or into the holder.
6.
Mount the cross brace
G
between the brackets
C
using
bolts
H
.
A
= 7 Nm
D
= 4 Nm
H
= 13 Nm
1659339-A
31
Содержание K-SERIES
Страница 11: ...Instructions 6 Instructions 1659339 A 11 ...
Страница 42: ...Küschall K Series Front side Rear side 42 1659339 A ...
Страница 43: ...Notes ...
