6.2.6 Adjusting the tipping point
Allen key (4 mm, 5 mm) / Socket spanner (8 mm)
■■■
1.
Remove the rear wheels, fold the backrest forward and
place the wheelchair on its back.
2.
Remove the bolts
A
,
B
and
E
.
3.
Remove the bolts
C
,
D
and
F
and slide the seat module
forwards or backwards.
If necessary the insert
I
has to be shifted inside
the seat module tube. Remove bolt
H
for fastening
the seat cover, shift insert
I
and re-insert bolt
H
and tighten.
The round nut
J
is positioned in the frame tube
with a grub screw which presses against the inner
wall of the tube. To reposition the round nut,
loosen the grub screw using an Allen key through
the frame hole and the thread of the round nut.
4.
Insert bolts
A
,
B
and
E
and tighten.
5.
Carry out the same setting on both sides.
There are 5 possible positions for the rear bracket and 5
possible positions for the front bracket.
Make sure to move the rear bracket and the front
bracket to the same number of holes.
A
= 7 Nm (high strength)
B
= 7 Nm (high strength)
C
= 7 Nm (Tuflok®)
D
= 7 Nm (high strength)
E
= 13 Nm (high strength)
F
= 7 Nm
1659339-A
15
Содержание K-SERIES
Страница 11: ...Instructions 6 Instructions 1659339 A 11 ...
Страница 42: ...Küschall K Series Front side Rear side 42 1659339 A ...
Страница 43: ...Notes ...
