Küschall Compact FF, Руководство по обслуживанию, Страница: 5 / 56

Safety
2 Safety
2.1 General Safety Information
WARNING!
Risk of injury or damage to property
– The procedures in this manual must only be
performed by a qualified technician.
– Use only original options and spare parts.
– Do not handle this product or any available
optional equipment without first completely
reading and understanding these instructions
and any additional instructional material such
as user manuals, installation manuals or
instruction sheets supplied with this product
or optional equipment.
– After each assembly, check that all fittings are
properly tightened and that all parts have the
correct function.
WARNING!
Risk of contamination
– Clean and disinfect the product before
servicing.
IMPORTANT!
Assembly of optional equipment might not be
described in this service manual. Refer to the
manual, delivered with the optional equipment.
– Additional manuals can be ordered from
Invacare. See addresses at the end of this
document.
– Due to regional differences, refer to your
local Invacare catalog or website for available
optional equipment or contact your local
Invacare representative. See addresses at the
end of this document.
IMPORTANT!
Some replacement parts are only available as
a kit. Always use the complete new kit when
replacing a part.
– Spare parts can be ordered from Invacare.
Refer to your local Invacare website to access
the electronic spare parts catalogue (ESPC).
IMPORTANT!
Refer to the user manual of this product for
information on
– Technical data
– Product components
– Labels
– Additional safety instructions
The information contained in this document is
subject to change without notice.
2.2 Personal safety information
These safety instructions are intended to help avoid
accidents during work and must be observed under all
circumstances.
All employees coming into contact with contaminated
products must regularly consult a company doctor.
Work clothing and personal protective equipment must
be available in necessary quantities and be in proper
condition. Reliable hand and surface disinfection must be
ensured.
WARNING!
Risk of contamination
– Clean and disinfect the product before
carrying out repairs.
2.3 General repair information
Repairs require a high level of expertise. These assembly instructions therefore break down the various tasks into
3 categories:
Requirement Symbol
Easy – technical understanding required ■□□
Medium – technical knowledge required
■■□
Difficult – technical knowledge and expertise in assembling required
■■■
The required tools and their sizes are listed before the instructions.
IMPORTANT!
– If possible, continue to use the old identification label; if this is not possible, the new identification label must
contain the same information and the old serial number. (Replacement of spare parts with serial numbers).
– When components are replaced it is necessary to ensure the traceability of the components replaced.
– If screws with thread locker are loosened, these must be replaced with new screws with thread locker.
Alternatively, new thread locker must be applied.
– If screws with circlip rings are loosened, these must be replaced with new ones.
– Parts that become damaged during removal must be replaced with new ones.
– All bolts must be tightened with the torque specified in the following instructions. Liquid high-strength and
low-strength adhesives are available. After the torque specifications, the adhesive to be used (high-strength
or low-strength) is indicated in brackets.
1659353-A 5