Küschall Compact FF, Руководство по обслуживанию, Страница: 19 / 56

Instructions
1. Remove the backrest cushion B and push the hook and
loop bands
C
upwards, until the backrest joint
A
is
invisible.
2. Remove the bolt
D
.
3. Slightly loosen bolt E .
4. Set the desired backrest angle, insert the bolt
D
in the
nearest hole and tighten.
5. Retighten bolt E .
6. Perform the same settings on both sides.
D
= 13 Nm
E
= 13 Nm
Visual Check
By looking from the side check that both backrest tubes are level and thus that the same angle has been set on both sides.
6.3.7 Installing the Joint for a folding Backrest
Allen key (4 mm, 5 mm) / Socket spanner (10)
■■□
Shorter rear frame (variant III) required.
1. Set the desired backrest angle, insert bolt A in the
nearest position (Pos. 1, 2 or 3) and tighten with
washer and nut. (With the curved backrest tubes, other
positions can be achieved in addition to the 3 positions
specified.)
2. Install the intermediate backrest tube
B
to the joint
housing using bolt E , washer and nut.
3. Insert the joint housing
C
into the rear frame
D
and
secure using bolt F , washer and nut.
A = 13 Nm
E = 13 Nm
F
= 7 Nm
Possible Backrest Angles
Position 1 (rear position): 82°, with curved backrest tube 90°
Position 2 (mid position): 86°, with curved backrest tube 94°
Position 3 (front position): 90°, with curved backrest tube 98°
1659353-A 19