Program Edit Mode
The OUTPUT Page
7-40
Each field in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand fields—as noted
in
, any adjustments made to the function-parameters on
the DSPMOD page are reflected in the corresponding function-parameters on the DSPCTL
page. The right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the programmable parameters. To access the parameters on
the subpage, highlight the function-parameter you wish to edit, and then press the > button
to move the cursor into the subpage.
Each function-parameter’s subpage contains the programmable parameters of the highlighted
function-parameter. By assigning control sources to modulate a function-parameter, you
can enable real-time control of your program’s sound and behavior. You can assign Src1 to
any control source, and can specify its maximum value with the Depth parameter. Src2 is
different—you can assign it to any control source, but can also assign a control source to its
maximum value with the DptCtl parameter. You can then specify the range of Src2’s depth
with the MinDepth and MaxDepth parameters.
The label of a function-parameter depends on its corresponding function-block in the current
layer’s algorithm. The above DSPMOD page corresponds to the following algorithm:
The OUTPUT Page
Press the OUTPUT soft button to get to the OUTPUT page, where you set the layer’s pre-
and post-FX panning. There are actually four different configurations of the OUTPUT page;
which one you see depends on whether the current layer uses a stereo keymap, and whether it
uses program FX or layer-specific effects (more on this in
The Program FX (FX) Page on page
The Layer FX (LYR_FX) Page on page 7-16
).
Note: The Forte SE features an easy shortcut for quickly assigning any of the Forte SE’s
realtime controllers (sliders, wheels, buttons, etc). to a currently selected parameter (such
as the Src1 and Src2 parameters above). Simply hold the Enter button and move the
desired controller.
