Kurzweil Flash Play PC4, Руководство музыканта

Страница: 168 / 335

The Effects Chain Editor
Effects Parameters
4-15
SmoothTime smooths the output of the expander’s envelope detector by putting a lowpass
filter in the control signal path. Smoothing will affect the Attack or Release times only when
this parameter is longer than one of the other times. The range is 0.0 to 228.0 ms.
Signal Dly
(Delay) puts a small delay in the signal relative to the sidechain processing, so
that the compressor (or gate) “knows” what the input signal is going to be before it has
to act on it. This means the compression can kick in before an attack transient arrives. In
the SoftKneeCompress and HardKneeCompress effects, delay is really only useful in feed-
forward configuration (FdbkComprs is “Out”). For other compressors, the delay can be
useful in feedback configuration (FdbkComprs is “In”). The range is 0 to 25 ms.
Ratio
is the amount of gain reduction imposed on the compressed signal, adjustable from
1.0:1 (no reduction) to 100:1, and Inf:1.
Threshold
is the level in dBFS (decibels relative to full scale) above which the signal begins
to be compressed. Adjustable from -79.0 to 0 dB.
MakeUpGain
allows additional output gain to compensate for gain reduction in the
compressor. It is essentially the same parameter as Out Gain, with which it is summed. The
minimum is -79.0, and the maximum summed gain (Make Out Gain) is +24.0
dB.
Expansion
Effects containing Expanders have these controls:
Atk
or Exp Atk (Attack), how fast the expander turns off when the input signal rises above
the threshold level, adjustable from 0.0 to 228.0 ms.
Rel
or Exp Rel (Release), how fast the expander turns back on after the signal drops below
the threshold level, adjustable from 0 to 3000 ms.
Ratio
or Exp Ratio, how much the gain is reduced below the expansion threshold, adjustable
from 1:1.0 (no expansion) to 1:17 (extreme downward expansion).
Threshold
or Exp Threshold, the level below which the signal is expanded, adjustable from
-79.0 to 0 dB.
In addition, the two-segment compressors with expander have separate Ratio and Threshold
controls for each of the compression segments.
Multiband Compression
The Multiband Compression effect has Attack, Release, Smooth, Signal Delay, Ratio,
Threshold, and MakeUp Gain parameters for each of the three bands (“Low”, “Mid”, and
“High”). In addition, it has:
Crossover1 and Crossover2. These set the frequencies which divide the three compression
frequency bands. The two parameters are interchangeable, so either may contain the higher
frequency value. The range is 16 to 25088 Hz, in increments of a semitone.