Kurzweil ExpressionMate, Руководство пользователя

Страница: 35 / 138

Editing and Creating Setups
Ribbon Configuration Parameters
25
more different simultaneous Program Change commands on one
channel. The result will be that only one Program Change will be
recognized.
If the MIDI Chan parameter of a zone is set to -NONE-, none of
the controls are processed for that zone, including those that send
to special destinations that don't involve MIDI. So, for example,
you can't set the MIDI Chan for Zone 3 to -NONE- and then use
notes from, say, a ribbon in that zone as the source for an
arpeggiator. If you really want to use control values in a zone but
don't want to send any MIDI from it, consider directing the
output to the Aux port or to an unused channel.
Stacking Zones
There will be times when ÒstackingÓ Zones on the same MIDI
channel will come in handy. Suppose you want to send two
different MIDI Controllers to the same program on your synth. In
this case, you can assign two Zones to the same channel, but with
different controller assignments.
HereÕs one example: say your synth uses Modulation (01) to open
a Þlter, and Data (06) messages to increase the ÞlterÕs resonance.
If you want to do both at the same time, you could use a single
CC pedal to send both messages. First, assign the CC pedal in
Zone 1 to ModWhl, and in Zone 2 to Data. Then assign both
Zones to the same MIDI channel. Now moving the CC pedal
opens or closes the Þlter and adds or removes resonance.
Keep in mind that the Factory Default settings will look at MIDI
notes coming in on Main MIDI channel 1 and process them
through the each zoneÕs parameters. This will double or triple the
number of notes going to your MIDI out channel. The most
versatile way to prevent this is to set the Low Key range to a note
that is higher than the High Key range (for example, NtLowKey:
C3 and NtHighKey: C2). You can also set the Global MergUnPro
to Neither (see page 81), which will affect all of your Setups,
disabling the Note processing features in the controller editor.
Ribbon Configuration Parameters
These parameters tell the Ribbon how to respond when you
touch it. When the Ribbon is in single-section mode, there are
three parameters for conÞguring the Ribbon: Rbn Split, Rbn