Kurtz Ersa HR 500, Перевод оригинального руководства по эксплуатации

Страница: 103 / 124

7 | Tutorial – Soldering or unsoldering a component
Start the process and work with the assistant.
7.6 Start the process and work with the assistant.
CAUTION
Risk of burning due to heated machine parts and PCB!
All heated machine parts as well as the surrounding housing parts and product sup-
port frame, the circuit board and the components become hot even during warm-up
to the process temperature [Tinit]!
Parts are particularly hot during the soldering process! After the soldering process,
wait until the device and the PCB have cooled down and reached non-hazardous tem-
peratures!
NOTE
Use the soldering fume extraction system!
Solder fumes are hazardous to health. For this reason, a soldering fume extraction sys-
tem should always be used. As regards the type of soldering fume extraction system,
we recommend using the Ersa “Easy Arm” with prefilter, HEPA, particle filter and ac-
tivated carbon filter. The device is equipped with a suitable connection for the solder-
ing fume extraction system. The soldering fume extraction system prevents the device
from accumulating dirt quickly.
In what follows, the entire soldering process is described along with all relevant
steps These include unsoldering, Placement the new component, Inspection the
position of the new component, Soldering and finally Inspection.
Start
Desoldering Placement Inspection Soldering Inspection
Process automation
Fig. 22: All five steps are activated
a) Click on the [Start] button.
ð The Wizard starts and executes the various steps divided into several tasks.
Perform all activities as required by the assistant.
Ersa GmbH Operating_instructions HR 500 DE 3BA00246-01 | Rev. 1 103 / 124