1. Hook the two s-hooks (B) onto the rear passenger seatbelt tabs (A1/A2) (See figure 1).
The end of the zip line with the cam buckle (E) should be on the driver’s side.
2. With your left hand, lock the rear driver’s side seatbelt in place by swiftly pulling
down on the seatbelt strap.
3. With right hand, grab extra zip line webbing (D) and apply constant pressure to the
extra webbing to ensure that the seatbelt stays in the locked position. (see figure 2)
4. With left hand, reach over and lock the passenger seatbelt in position using the
same swift pulling motion.
5. With the 2 seatbelts in the locked position pull on the extra zip line webbing in
your right hand to remove all slack from the zip line. (See figure 3)
6. Roll up extra webbing (D) towards cam buckle (E) and secure using bungees &
toggle system. (See figures 4 & 5).
7. Tug on each seatbelt before attaching the dog to ensure they are in the correct
locked position. (This should be done before each trip)
8. Place Carbineer (F) onto zip-line (C).
9. Attach leash clip to harness D-ring (H).
10. Locate appropriate leash nook (J) that permits Fido to sit up and lay down and
loop onto the carbineer (F).
AUTO ZIP LINE - SEATBELT INSTALLATION INSTRUCTIONS
Kurgo products
•
2D Fanaras Drive, Salisbury, MA 01952
•
tel: 877-847-3868
•
kurgo.com
•
KEY
Seatbelt tab
(rear drivers)
Seatbelt tab
(rear passengers)
S-hook
Nylon zip-line
Extra zip-line webbing
Cam buckle
Carabineer
Wander leash/tether
Harness D-ring
Bungee & toggle
Leash nook
More setup
options on
reverse side
Maintain tension on
seatbelt in locked position
while adjusting the other
seatbelt connection
Located on back
of harness
Passenger side
seatbelt tab
WARNING
• Only secure the Auto Zip Line to OEM car manufactured and
installed parts on your vehicel
• Never travel with a passenger in the rear of the car when the
Auto Zip Line is installed
• Pets should not be left unattended in vehicle at any time
• Ensure proper installation of the Zip Line before each trip
