Kuppersberg INBOX, Технический паспорт, Страница: 9 / 28

9
ENGLISH
Cooker hood
TECHNICAL PASSPORT
INSTALLATION
The minimum distance between
the supporting surface for the cooking
equipment on the hob and the lowest
part of the range hood must be not less
than 45cm from electric cookers and
50cm from gas or mixed cookers.
If the instructions for installation for
the gas hob specify a greater distance,
this must be adhered to.
ELECTRICAL CONNECTION
The mains power supply must
correspond to the rating indicated
on the plate situated inside the hood.
If provided with a plug connect the
hood to a socket in compliance with
current regulations and positioned in
an accessible area, after installation.
If it not fitted with a plug (direct
mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch
in accordance with standards which
assures the complete disconnection of
the mains under conditions relating to
over-current category III, in accordance
with installation instructions.
Warning! Before re-connecting
the hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled. The hood is provided with
a special power cable; if the cable
is damaged, request a new one from
Technical Service.
MOUNTING
Very heavy product; hood handling
and installation must be carried out by
at least two persons.
• Check that the product purchased
is of a suitable size for the chosen
installation area.
• Remove the charcoal (*) filter/s if
supplied (see also relative paragraph).
This/these is/are to be mounted only if
you want lo use the hood in the filtering
version.
• Check (for transport reasons) that
there is no other supplied material
inside the hood (e.g. packets with screws
(*), guarantees (*), etc.), eventually
removing them and keeping them.
• If possible, disconnect and move
freestanding or slide-in range from
cabinet opening to provide easier
access to rear wall/ceiling. Otherwise
put a thick, protective covering over
countertop, cooktop or range to protect
from damage and debris. Select a flat
surface for assembling the unit. Cover
that surface with a protective covering
and place all canopy hood parts and
hardware in it.
• In addition check whether near
the installation area of the hood (in
the area accessible also with the hood
mounted) an electric socket is available
and it is possible to connect a fumes
discharge device to the outside (only
suction version).
Before beginning installation:
• Carry out all the masonry work
necessary (e.g. installation of an electric
socket and/or a hole for the passage of
the discharge tube).