21
ENGLISH
TECHNICAL PASSPORT
Dishwasher
NOTE: I
f operate from step 1 to step
2, the fi lter system will be removed;
while operate from step 2 to step 1, the
fi lter system will be installed
3
.
Filter assembly
For best performance and results,
the fi lter assembly must be cleaned. The
fi lter effi ciently removes food particles
from the wash water, allowing it to be
recirculated during the cycle. For this
reason, it is a good idea to remove the
larger food particles trapped in the
fi lter after each wash cycle by rinsing
the semicircular fi lter and cup under
running water. To remove the fi lter
assembly, pull on the cup handle in
the upward direction. The entire fi lter
assembly should be cleaned once a
week. To clean the coarse fi lter and the
micro fi lter, use a cleaning brush. Then,
reassemble the fi lter parts as shown in
the fi gures above and reinsert the entire
assembly in the dishwasher, positioning
in its seat and pressing downward. The
dishwasher must never be used without
the fi lters. Improper replacement of the
fi lter may reduce the performance level
of the appliance and damage dishes
and utensils.
WARNING!
Never run the dishwasher without
the fi lters in place. When cleaning the
fi lters, don’t knock on them. Otherwise,
the fi lters could be contorted and the
performance of dishwasher could be
debased.
Cleaning the Spray Arms
It is necessary to clean the spray
arms regularly for hard water chemicals
will clog the spray arm jets and bearings.
To remove the spray arms, screw
off the nut clockwise to take out the
washer on top of the spray arm and
remove the arm. Wash the arms in soapy
and warm water and use a soft brush
to clean the jets. Replace them after
rinsing thoroughly.
