Kuma Stoves K-SEQ, Инструкция по установке и эксплуатации, Страница: 27 / 30

27
2. Wood is well seasoned but has a lot of surface moisture. Your wood supply must be covered.
Check your tarps or other covering to see that no rain or snow is getting to your wood. Wood
shoud be covered on top, but open on the sides to allow air movement to aid in drying.
3. Chimney and/or the chimney cap needs to be cleaned. Your chimney should be checked and
cleaned if necessary every few months. Even a small amount of build up can cause a draft
restriction, for example: ¼ inch of build up on the side wall of an 8” chimney reduces the effective
area of the chimney by about 20%. Pay close attention to the chimney cap, especially if it has a
screen. Screened chimney caps can become blocked enough to restrict flow in just a few weeks.
4. Catalytic combustor is plugged with ash. Clean the catalyst in place using a slight to moderate
amount of air pressure blown through the baffle grid removing ash from the comubster cells.
5. Check the air supply to the stove. If ash has built up around the air sliders, clean with a brush
and/or slight air pressure.
6. Atmospheric conditions. Occasionally, barometric episodes occur that affect draft, thereby
affecting stove performance. If your stove has been working fine and performance drops
suddenly, this is most likely the cause, and will usually go away within a few days.
7. Your fuel load may be too small or the wood size too large for the coal bed. A small bed of coals
requires re-kindling to build up the heat, only put large chunks of wood on a very hot and active
bed of coals.
Burn time too short.
1. Your fuel load may be too small or the wood size too large for the coal bed. A small bed of coals
requires re-kindling to build up the heat, only put large chunks of wood on a very hot and active
bed of coals. If there are large chunks of charred wood left after the fire has gone out, the coal bed
was not hot enough.
2. Fuel quality. Harder, denser woods produce longer burn times. Likewise, softer woods produce
shorter burn times.
3. Check the main door gasket and glass gasket for proper seal. See for instructions on checking
your gaskets.