Kuka IONTEC KR 20 R3100, Руководство по сборке

Страница: 27 / 344

Modifications
After modifications to the industrial robot, checks must be carried out to
ensure the required safety level. The valid national or regional work safety
regulations must be observed for this check. The correct functioning of all
safety functions must also be tested.
New or modified programs must always be tested first in Manual Reduced
Velocity mode (T1).
After modifications to the industrial robot, existing programs must always
be tested first in Manual Reduced Velocity mode (T1). This applies to all
components of the industrial robot and includes e.g. modifications of the
external axes or to the software and configuration settings.
Faults
The following tasks must be carried out in the case of faults in the indus-
trial robot:
• Switch off the robot controller and secure it (e.g. with a padlock) to
prevent unauthorized persons from switching it on again.
• Indicate the fault by means of a label with a corresponding warning
(tagout).
• Keep a record of the faults.
• Eliminate the fault and carry out a function test.
3.5.2 Transportation
Manipulator
The prescribed transport position of the manipulator must be observed.
Transportation must be carried out in accordance with the operating in-
structions or assembly instructions of the robot.
Avoid vibrations and impacts during transportation in order to prevent
damage to the manipulator.
Robot controller
The prescribed transport position of the robot controller must be observed.
Transportation must be carried out in accordance with the operating in-
structions or assembly instructions of the robot controller.
Avoid vibrations and impacts during transportation in order to prevent
damage to the robot controller.
External axis (optional)
The prescribed transport position of the external axis (e.g. KUKA linear
unit, turn-tilt table, positioner) must be observed. Transportation must be
carried out in accordance with the operating instructions or assembly in-
structions of the external axis.
3.5.3 Start-up and recommissioning
Before starting up systems and devices for the first time, a check must be
carried out to ensure that the systems and devices are complete and op-
erational, that they can be operated safely and that any damage is detec-
ted.
The valid national or regional work safety regulations must be observed
for this check. The correct functioning of all safety circuits must also be
tested.
KR IONTEC
MA KR IONTEC V4 | Issued: 11.05.2021 www.kuka.com | 27/344
Safety