KUHN AXIS 20.1, Руководство оператора

Страница: 171 / 216

Spreading operation
159
B
AXIS
20.1
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
AXIS 50.1 W
B.9 Faults and possible causes
Requirements for elimination of faults
Please make sure the following conditions are met before eliminating faults.

PTO shaft and engine of the tractor are switched off and locked to prevent ac-
cidental starting.

The hopper is standing on firm, even ground.
n
WARNING
Risk of injury and accident from missing or inadequate trou-
bleshooting.
Delayed or unprofessional troubleshooting can lead to uncalcula-
ble risks with negative effects to man, machine and the environ-
ment.
 Have any faults corrected immediately .
 Correct faults yourself only if you have the appropriate
qualifications.
NOTICE
Please take particular note of the warnings in chapter 3: Safety, page 5 and sec-
tion C: Maintenance and repair, page 164 , before eliminating faults.
Fault Possible cause/action
Uneven fertiliser distribution

Remove clumps of fertiliser on spreading discs, vanes
and output ducts.

Opening slides do not open completely. Check slides
opening position.

Drop point incorrectly set. Correct setting.
Too much fertiliser on the tractor
driving track

Check vanes and outlets and replace faulty parts imme-
diately.

The fertiliser has a smoother surface compared to the
calibration tested fertiliser. Select drop point setting later
(e.g. from 4 to 5).

PTO speed too low. Adjust speed.
Too much fertiliser in the overlap
zone

The fertiliser has a rougher surface compared to the cal-
ibration tested fertiliser. Select drop point setting earlier
(e.g. from 5 to 4).

PTO speed too high. Adjust speed.