screws of the carrier.
Loosening the fixing screws of spool carriers.
Slide the carrier to or away from the
filament inlet to a position that leaves
approximately 1 cm between the spool's
outer rim and the limit switch. Make sure
that the filament enters the inlet at an
angle of 85-90°.
Refasten the fixing screws.
Admissible distance and inlet angle.
[Expert Control] screen
NOTICE
The Expert Control menu should be used by skilled operators only. It has been designed for test and
troubleshooting purposes. Persons unfamiliar with the 3D printer must not mess around with functions
provided here.
The positions of the extruder head and the print table are not compared during manual operation.
Incautious operation may lead to massive damage of the extruder head and the print bed.
Be careful not to crash the print table and the extruder head.
For maintenance and test reasons, after a crash
or to reduce lead times, e.g. if you still need to
work on a print file but want the 3D printer to be
ready for operation, manually moving the
