Kuhling&Kuhling RepRap Industrial, Руководство по эксплуатации

Страница: 13 / 24

No. Description Content/Function
3 Web Interface URL
Needed to connect to your RepRap Industrial via the network
→
additional information
4 Version numbers
The valid version numbers of your RepRap Industrial's hardware, the installed
RepRapOnRails software and the microcontroller firmware for your
information. Please provide these numbers for identification in case of service
requests.
Changing the filament
When the filament limit switch at the filament supply registers the end of the filament strand on the
spool, the 3D printer stops automatically and signals lack of material at the touchscreen.
If you want to remove the filament for other reasons (e.g. to use a differently colored material), the
following description applies also.
Required tools
diagonal cutters
Refilling
If you want to continue printing with the same type of plastic, the change of the filament spool is
quite easy. You have to manually remove remaining filament from the supply hose, change and, if
need be,
adjust the spool carriers and insert the new strand.
Go to the Setup menu and start the [Unload Filament] wizard and follow the on-screen 1.
instructions.
Then open Setup menu again, and follow the [Load Filament] wizard.
2.