7
2.2.
Operation
2.2.1.
Operate light with touch or encoder button
The left area is TFT Displayer and touch, chick item or value with finger will to complete
operation of set light setting(parameters) or view light state.
The area on the right hand side is rotary encoder with button, As auxiliary input interface,
if disable touch function,, the encoder can been choose to set or view the item, and
then press the encoder button to confirm the selection, rotary encoder again set the
parameter value, finally, Press encoder button one again to save value or setting.
2.2.2.
Parameter value setting
When the selected item is value need to been modified, the dialog shown in Figure 4 will popup.
Figure 4 Dialog of value setting
Modify value
：
Can quickly modify value via pull the slider to the desired position, or click
the button of ‘up’ or ‘down’ whit finger on the right side to set the exact desired value,
another way is roll encoder on the right hand side of panel.
Apply value
：
When Value had been modified, Then press the bottom of ‘apply’ in the left
corner to apply to the light, but hav’t saved
；
Save Value
：
Any time, click on the lower right corner of the "OK" button, the setting will
been saved into internal memory.
2.3.
Boolean parameter setting
when the selected parameters is a Boolean value (such as ON or OFF), can directly modify
setting by chick corresponding item, the setting will been saved right now.
When the parameter is a key item, chick corresponding item, a dialog shown in Figure 5
will been popup ask for the confirm. Chick ‘sure’ to confirm.
Figure 5 Dialog of confirm
