KUDOS HYCP-400, Инструкции по безопасной эксплуатации и техническому обслуживанию

Страница: 15 / 16

Operation Manual - III
4. Place the working cable and terminal into the open of C-head. To
reach the best results, the cable and terminal must be positioned
at the CENTER of the open top to balance the compression. It
might damage the dies or even deform the C-head if the cable and
terminal are off-center.
5. Exercise the moving handle back and forth to push the piston and
lower die forwards.
6. The rapid motion of piston with low hydraulic pressure will convert
to a slow motion with high pressure after the upper and lower dies
are tightly pressed.
7. Operation completes when the hydraulic pressure reaches 700 bars
at which the relief valve releases the internal pressure. Repeat step 1
and remove the cable. Pull up the spring pin (#40) to remove the
upper die, and press down the arresting pin (#74) to remove the
lower die.
8. Clean the product and dies after use. Apply rust preventive oil to the
product and dies before putting them back to the carrying case.
Page: 7 KuDos Industrial Inc. U.S.A.