67
MAINTENANCE
ENGLISH
B
Replacing Transmission Oil Filter [HST]
To avoid serious injury or death:
A
Be sure to stop the engine and remove the key
before changing the oil filter.
A
Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter must be changed every 200 service hours.
2. Place an oil pan underneath the oil filter. (Do not drain
oil.)
3. Remove the oil filter by using the filter wrench.
4. Apply a slight coat of oil onto the filter gasket.
5. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
6. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
A
To prevent serious damage or premature failure to the
hydraulic system, use only a KUBOTA genuine filter.
B
Adjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct,
vibration in the front wheel can occur.
C
Check and Adjustment of the Front Axle End Play
1. Lift up and securely block the front of the machine.
2. Measure the clearance (L) between the front axle (4)
and front axle support (3).
3. If the measurement exceeds the allowable limit, adjust
the nut (1).
A
When fastening the center pin (2), tighten the nut so
that the front axle maybe oscillated smoothly by hand.
(1) Transmission oil filter [HST]
(1) Transmission oil filter [HST]
(1) Nut
(2) Center pin
(3) Front axle support
(4) Front axle
(5) Plain washer
(L) Front axle end play
Front axle end play
(L)
Factory
spec.
0 to 0.2 mm
(0 to 0.008 in.)
Allowable
limit
0.5 mm
(0.02 in.)
Содержание ZD1211
