Kubota U50-5, Руководство по эксплуатации

Страница: 214 / 236

212
W9272-8135-1
05/2020
Maintenance
Drive unit oil - change

Park the machine on level ground so that the drain plug (figure below, position 3) is positioned at the bottom.

Place a catch tray with a minimum capacity of 2 l under the drain plug.

Remove the drain plug and let the oil drain completely. Install
the drain plug with a new sealing ring on it.

Remove the oil filler plug (2) and oil level screw (1).

Fill oil as specified in the "Operating materials" section
(page 180). The oil level is the lower edge of the thread.
Capacities: 0.9 l

Refit the oil filler plug and the set screw with a new sealing ring and tighten it.

Perform the same service on the second drive unit.
Interior air filter - check/clean/change

Open the heating and air-conditioner unit service cover
(page 157).

Remove the screw (1).

Open the cover plate (2).

Remove the interior air filter (3).
Checking

Inspect the interior air filter for contamination and damage. In case of heavy contamination, replace the interior
air filter.
Only change the oil when the drive unit is warm to the hand; if not, drive the machine warm.
If the machine is operated in a particularly dusty envi-
ronment, the interior air filter must be checked more of-
ten.
KX060-05_153
1 1 2 2
3 3
KX060-05_154
1 1 2 2
3 3