Kubota R065, Руководство оператора

Страница: 97 / 117

69 PERIODIC SERVICE
B
Cleaning and checking air cleaner
element
Open the engine cover and remove the cover and the
outer filter element, clean the filter element, case interior
without removing the inner element and reassemble the
filter element and cover.
During reassembly, take care to install the cover so that
its TOP mark (arrow) faces upwards.
A
If the machine is used in an excessively dusty
environment, the air filter elements must be inspected
and cleaned / replaced more often than indicated in
the maintenance chart.
A
The air filter elements are dry elements. Do not oil
them.
A Do not operate the machine without the air filter
installed.
B
Checking Fuel Line and Intake Air Line
1. Check to see that all lines and hose clamps are tight
and not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
B
Checking wheel nuts
Refer to the "Tire" section.
B
Cleaning the filter element
If the filter element is heavily clogged or oily, change it. If
it is only dusty, you can clean it with compressed air.
To avoid personal injury or death:
A Wear eye protectors when cleaning with
compressed air.
C Blowing with compressed air
The pressure should not exceed 3 bar and the cartridge
should be blown clean from inside to outside until the dust
deposits are removed.
A If the engine performance is still too low after cleaning
the air filter elements or the exhaust is colored black,
replace the air filter elements.
(1) Outer element
(2) Inner element
(3) Clamp
(4) Cover