Kubota R065, Руководство оператора

Страница: 94 / 117

PERIODIC SERVICE 66
B
Checking and tightening loose bolts and
nuts
Check the bolts and nuts and tighten them if necessary.
B
Checking electrical wiring for short-
circuits and loose terminals
To avoid personal injury or death:
A
Never wear metal rings or metal watch bands.
You can make a ground for the electric circuit
and get a burn on your hand or arm.
A
Know the electrical circuit before you connect
or disconnect an electrical component. A
wrong connection can cause injury or damage.
Only qualified electricians are allowed to work
on the electrical system.
Check the electrical system carefully, since any faults will
cause malfunctions or serious damage.
B
Checking the lamps and instruments
1. Check that the lamps flash and light normally.
2. Check that the instruments, alarm lamps and warning
lights work normally.
B Testing the horn
Check that the horn works.
B
Checking the machine for leaks
Check the machine for leaks in the fuel system, the
radiator, the hydraulic system and the engine.
B Checking and cleaning after operating in
muddy areas
1. If the machine is used in muddy areas, immediately
wash it with water to remove the mud and dirt.
2. After washing it, check and lubricate the joints of the
propeller shaft.
EVERY 50 HOURS SERVICE
B
Checking the battery condition
To avoid the possibility of a battery explosion:
For refillable type battery, follow the instructions
below.
A
Do not use or charge the refillable type battery
if the fluid level is below the LOWER (lower limit
level) mark. Otherwise, the battery component
parts may prematurely deteriorate, which may
shorten the battery's service life or cause an
explosion. Check the fluid level regularly and
add distilled water as required so that the fluid
level is between the UPPER and LOWER levels.
To avoid personal injury or death:
A Never remove the vent caps while the engine is
running.
A
Keep electrolyte away from eyes, hands and
clothes. If you are spattered with it, wash it
away completely with water immediately and
get medical attention.
A
Wear eye protection and rubber gloves when
working around the battery.
A Before inspection or dismounting the battery,
be sure to turn off the engine and turn the
starter switch to the "STOP" position.
A
When removing the battery, always disconnect
the negative ground cable first. When installing
a battery, always connect the ground cable
last. This prevents a possible explosion caused
by sparks.
A Always wear eye protection when working with
the battery.
(A) "Upper level"
(B) "Lower level"