Kubota R065, Руководство оператора

Страница: 102 / 117

PERIODIC SERVICE 74
B
Replacing HST oil filter
To avoid personal injury or death:
A
Never remove the filter immediately after the
engine has stopped, or hot hydraulic oil may
rush out, causing scalding.
1. Loosen the nut located the bottom of the filter and
remove the filter.
[The hexagon nut: 24 mm]
2. Replace it to new one.
Tightening torque: 73.6 to 83.4 N-m
A
After changing the filter, start the hydraulic system
briefly and then check the oil level.
B
Changing hydraulic oil and the suction
filter
To avoid personal injury or death:
A
Always stop the engine before changing oil.
A Never open the drain plug immediately after the
engine has stopped, hot hydraulic oil may rush
out, causing scalding.
1. Remove the drain plug (hexagon head screws 8 mm)
from the bottom of the tank and drain the oil.
2. Remove the bolt from the tank bottom cover and then
remove the cover.
3. Replace the suction filter (hexagon nut: 60 mm).
4. Check the gasket for damage and replace gasket if
necessary.
5. Retighten the drain plug, and attach the tank bottom
cover.
6. Open the access flap and the oil port cap for the
hydraulic oil tank and fill hydraulic oil up to the
specified amount and then close the oil port cap and
the flap.
(1) HST oil filter
(1) Suction filter
(2) Hydraulic oil tank
(3) Bottom cover