Kubota R065, Руководство оператора

Страница: 100 / 117

PERIODIC SERVICE 72
B
Replacing return filter
To avoid personal injury or death:
A Never remove the filter immediately after the
engine has stopped, or hot hydraulic oil may
rush out, causing scalding.
1. Remove the cover on the hydraulic oil tank.
2. Loosen the filter with a wrench and remove the filter.
3. Tighten the new return filter.
A After changing the filter, start the hydraulic system
briefly and then check the oil level.
B
Changing the fuel filter
To avoid personal injury or death:
A
Always stop the engine before changing the
fuel filter.
A Keep sparks and flames away from the diesel
fuel, or serious personal injury results.
Allow the engine to cool completely.
1. Close the shutoff-valve at the water separator.
2. Remove the filter with filter wrench.
3. Apply a light film of fuel to the seal of the new filter and
turn in tightly by hand.
4. Open the shutoff-valve.
EVERY 800 HOURS SERVICE
Perform inspection and servicing for every 50 hours of
operation at the same time.
B Adjusting Engine Valve Clearance
Consult your local KUBOTA dealer for this service.
(1) Oil port plug front axle (both side)
(2) Oil port plug rear axle (both side)
(3) Oil plug
(1) Return filter
(2) Hydraulic oil tank
(3) Cover
(1) Fuel filter
(2) Shutoff-valve