PERIODIC SERVICE
86
B
Replacing Light Bulb
B
Replacing Head Lamp
To avoid personal injury:
A
Be careful not to drop the bulb, hit anything
against the lamp, apply excess force, and get
the lamp scratched. If broken, glass may cause
injury. Pay more attention to halogen lamps in
particular, which have high pressure inside.
A
Before replacing the lamp, be sure to turn off
the light and wait until the bulb cools down,
otherwise, you may get burned.
1. While pushing the right and left lock buttons, pull and
remove the electrical connector.
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
4. Replace with a new bulb and reinstall the head lamp
assembly in the reverse order.
A
Be sure to use a new bulb of the specified wattage.
A
Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
B
Lubricating Points
B
Adding Washer Liquid
1. Remove the cover and open the washer liquid tank
cap.
2. Add a proper amount of automobile washer liquid.
Light
Capacity
Head light
12V, 55 / 60 W (H4)
Turn signal / hazard light (Front)
12V, 21 W
Turn signal / hazard light (Rear)
12V, 21 W
Brake stop light / Tail light
12V, 21 / 5 W
Front work light
12V, 21 W
Work light (for outer roof)
12V, 55 W
Dome light (room lamp)
12V, 5 W
Front position light
12V, 10 W
Number plate light
12V, 10 W
(1) Electrical connector
(2) Lock buttons
(3) Rubber boot
(4) Clamping fixture
(5) Bulb
(A)"Base's wider projection to face
upward"
(1) Door hinge
(2) Rear window hinge
Tank capacity
1.0 L
(1) Cover
(2) Knob bolt
(3) Washer liquid tank cap
