Kubota M7040SU, Руководство оператора

Страница: 82 / 90

PERIODIC SERVICE 64
B
Lubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
EVERY 600 HOURS
B
Changing Transmission Fluid
To avoid personal injury:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to prescribed level.
A
Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
B
Changing Front Axle Gear Case Oil &
Front Differential Case Oil
[4WD]
1. To drain the used oil, remove the drain plugs at the
both front axle gear cases and filling plugs, and drain
the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil level check plug at the front differential
case.
4. Fill with the new oil of the specified amount from both
filling ports on the front axle gear case.
5. Finally fill with the new oil up to the lower rim of check
plug port on the front differential case.
(See "LUBRICANTS" in "MAINTENANCE" section.)
6. After checking oil is visible through the opening of
check plug, reinstall filling plugs and check plug.
(1) Front wheel hub cover
Oil capacity 44 L (46.5 U.S.qts)
(1) Drain plug
(1) Dipstick
(2) Oil inlet (A) Oil level is acceptable within
this range.
Oil capacity
Front Axle Gear Case
3.0 L (3.2 U.S.qts.)
for each side
Front Differential Case 6.6 L (7.0 U.S.qts.)