Kubota M7-132, Руководство оператора

Страница: 286 / 332

6. Replacing hydraulic oil filter
(return)
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the
oil filter.
• Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Place the oil pan underneath the hydraulic oil filter.
2. Using a wrench, remove the filter cover.
3. When oil is no longer dripping from the exposed
area, remove the element and replace it with a new
one.
Make sure at this time that the o-ring is mounted on
the element mounting part.
Power shift transmission type
(1) Hydraulic oil filter cover
(2) Nut
(3) Element
(4) O-ring
CVT type
(1) Hydraulic oil filter cover
(2) Nut
(3) Element
(4) O-ring
4. Mount after cleaning the filter cover. If the o-ring is
damaged, make sure to replace it.
5. Fill the transmission oil up to the upper line of the
sight glass.
(1) Filling plug
(1) Sight glass (A) Oil level is acceptable within
this range
6. After running the engine for a few minutes, stop the
engine, wait for 10 minutes and check the oil level
again, add oil to the prescribed level.
7. Make sure that the transmission fluid doesn’t leak
past the seal on the filter.
NOTE :
• Check the transmission fluid level under the
following conditions:
a. Park the machine on a flat surface.
b. Lower the rear 3-point hitch and front
end loader (if equipped).
c. Raise the front 3-point hitch (if
equipped).
d. Disconnect all the remote control valve
hoses.
e. Shut off engine and wait for 10 minutes.
7. Replacing power steering oil filter
WARNING
To avoid personal injury or death:
PERIODIC SERVICE EVERY 500 HOURS
280
M7132, M7152, M7172