Kubota M7-132, Руководство оператора

Страница: 22 / 332

(1) Brake pedal (LH)
(2) Brake pedal (RH)
(3) Brake pedal lock (A) Whenever travelling on the
road
• Check the front wheel engagement. The braking
characteristics are different between a 2 and 4-
wheel drive. Be aware of the difference and use
carefully.
• When driving down a slope, ensure that the 4-
wheel drive is engaged to increase traction (if
equipped).
• Always slow the tractor down before turning.
Turning at high speed may tip the tractor over.
• Observe all local traffic and safety regulations. Use
the registration plate as required.
(1) Registration plate
• Turn the headlights on. Dim them when meeting
another vehicle.
• Drive at speeds that allow you to maintain control at
all times.
• Do not apply the differential lock while travelling at
road speeds. The tractor may run out of control.
• Avoid sudden motions of the steering wheel as they
can lead to a dangerous loss of stability. The risk is
especially great when the tractor is travelling at
road speeds.
• Do not operate an implement while the tractor is on
the road. Lock the 3-point hitch in the raised
position. For travelling with the ride control on,
however, keep the 3-point hitch unlocked.
• Set the 3-point hitch lock button in the “LOCK”
position to hold the implement in the raised
position.
Standard model
(1) 3-point hitch lock button
Premium, Premium KVT model
(1) 3-point hitch lock button
• If you drive the tractor with a trailer loaded with
something heavy in tow and step on the brake
pedal, the tractor is pushed forward by the trailer
due to an abrupt slowdown. This may fail to keep
the tractor under control.
Before stepping on the brake pedal, press the
transmission ratio lock button for smooth slowdown
in combination with the engine brake (
Premium
KVT model).
PARKING THE TRACTOR
• Disengage the PTO, lower all implements to the
ground, place all control levers in their neutral
positions, set the handbrake, stop the engine,
remove the key from the ignition and lock the CAB
door (if equipped).
Leaving transmission in gear with the engine
stopped will not prevent tractor from rolling.
• Make sure that the tractor has come to a complete
stop before dismounting.
SAFE OPERATION
16
M7132, M7152, M7172