Kubota M7-132, Руководство оператора

Страница: 198 / 332

• Avoid changing gears when climbing or
descending a slope.
• If operating on a slope, never disengage the
clutch or shift levers to neutral. Doing so could
cause loss of control.
• Do not drive the tractor close to the edges of
ditches or banks which may collapse under the
weight of the tractor, especially when the
ground is loose or wet.
1. Be sure wheel tread is adjusted to provide
maximum stability.
(See WHEEL ADJUSTMENT on page 233.)
2. Slow down for slopes, rough ground, and sharp
turns, especially when transporting heavy, rear
mounted equipment.
3. Before descending a slope, shift to a gear low
enough to control the speed without using brakes.
3. Transporting the tractor safely
1. The tractor, if damaged, must be carried on a truck.
2. Secure the tractor with chains or straps sized
appropriately. Make sure all loading ramps are
properly sized. Make sure all local tie-down
requirements are met.
3. Follow the instructions below when towing the
tractor. Otherwise, the tractor’s power train may be
damaged.
• Set all the shift levers to “NEUTRAL” position.
• If possible, start the engine and select 2WD; if
creep speed is fitted ensure that it is
disengaged.
• Tow the tractor using its bolt coupling (1)
located at front bumper or front 3-point hitch.
• Never tow faster than 10 km/h (6.2 mph).
(1) Bolt coupling
(1) Bolt coupling
4. Directions for use of power
steering
• Power steering is activated only while the engine is
running. Slow engine speeds make the steering a
little heavier. While the engine is stopped, the
tractor functions in the same manner as tractors
without power steering.
• When the steering wheel is turned all the way to the
stop, the relief valve is activated. Do not hold the
steering wheel in this position for a long period of
time.
• Avoid turning the steering wheel while the tractor is
stopped, or tyres may wear out sooner.
• The power steering mechanism makes the steering
easier. Be careful when driving on a road at high
speeds.
OPERATING THE TRACTOR OPERATING TECHNIQUES
192
M7132, M7152, M7172