Kubota M6H-101, Руководство оператора

Страница: 117 / 202

(1) Draft control lever (A) "UP"
(B) “SENSITIVE”
(C) “INSENSITIVE”
(D) “FLOAT”
4. Mixed control
In draft control, when draft decreases, the implement
automatically lowers to increase draft.
However, the implement sometimes lowers too much.
To limit the degree to which the implement can be
lowered, set the position control lever at the lowest
working depth desired for the implement. Lower the
draft control lever to the point where the implement is at
the desired depth.
This stops the implement from going too deep and
causing loss of traction and ground speed.
(1) Ground surface
(2) Implement penetration limit
(3) Light soil
5. Float control
Place both the draft control lever and the position
control lever in the float position to make the lower links
move freely along with the ground conditions.
6. 3-point hitch lowering speed
WARNING
To avoid personal injury or death:
• A fast lowering speed may cause damage or
injury. Lowering speed of implement should be
adjusted to 2 or more seconds.
The lowering speed of the 3-point hitch can be
controlled by adjusting the 3-point hitch lowering speed
knob.
(1) 3-point hitch lowering speed
knob
(A) “FAST”
(B) “SLOW”
(C) “LOCK”
REMOTE HYDRAULIC
CONTROL SYSTEM
The hydraulic auxiliary control valves can be installed
with up to 3 segments.
1. Remote control valve
There are 2 types of remote valves available for these
models.
• Double acting valve with detents and self canceling:
This valve may be placed in the detent mode. The
lever will stay in this position until the pressure
reaches a predetermined level or a cylinder
reaches the end of its stroke. Then it will
automatically return to neutral.
• Double acting valve with float position:
This valve may be placed in the float mode with the
control lever all the way forward. The cylinder is
free to extend or retract, letting an implement such
as a loader bucket follow the ground.
3-POINT HITCH CONTROL SYSTEM HYDRAULIC UNIT
M6S-111,M6L-111,M6H-101
111