Kubota M4N-071, Руководство оператора

Страница: 64 / 152

14. Travel speed limiter
The highest travel speed is reachable when the engine
rpm is at around the middle level with the maximum
travel speed range.
This provides for a fuel-efficient run while traveling
along roads, pulling a trailer, and so on. Step on the
foot throttle, and the engine rpm rises proportionally
and the travel speed goes up accordingly.
But the engine speed is limited to 2080 rpm or so, and
it does not increase even if the foot throttle is
increased.
When the main gear shift lever is set to the
[H-6]
position, the rev-limiter indicator illuminates.
(1) Rev-limiter indicator
15. Main gear shift lever
The main gear shift is fully synchronized to shift without
stopping.
IMPORTANT :
• The main gear shift may be shifted between
speeds on-the-go, but the clutch must be
depressed.
16. Range gear shift lever
The range gear shift can only be shifted when the
tractor is completely stopped and the clutch is
depressed.
IMPORTANT :
• To avoid transmission damage, depress the
clutch pedal and stop the tractor before shifting
between ranges.
16.1 Creep speed (if equipped)
WARNING
To avoid personal injury or death:
• When you leave the tractor, be sure to apply the
parking brake and stop the engine.
• In applying the brakes:
– The torque of the wheel axle is extremely
high while creep speed is being used. Be
sure to step down on the clutch pedal
completely before applying the brakes, or
they will not work.
– When starting to operate the tractor, be sure
to release the parking brakes.
Misuse of the brakes may cause damage to
the transmission and is therefore not
acceptable to KUBOTA for coverage under
the warranty.
IMPORTANT :
• Press the clutch pedal completely down and
stop the tractor's motion before shifting the
range gear shift lever.
Shift the range gear shift lever to to obtain low
speeds.
This shifting requires clutch operation.
(1) Range gear shift lever Creep on
Creep speed should be used only when doing one
of the following jobs:
• Deep rotary-tilling and harrowing
• Planting
• Turf application
Creep speed cannot be used for any of the
following jobs:
• Pulling a trailer
• Front-loader operation
• Front-blade operation
• Earth-moving
• Entering and leaving a field
• Loading onto and unloading from a truck
17. Shuttle shift lever
WARNING
To avoid personal injury or death:
• If the shuttle shift lever is moved in forward or
reverse position while the parking brake is
applied, an alarm buzzer will sound.
OPERATING THE TRACTOR STARTING THE TRACTOR
58
M4N-071, M5N-091, M5N-111