Kubota L4701, Руководство оператора

Страница: 108 / 142

1. Inspect the brake pedal for free travel and smooth
operation.
2. Adjust the brake pedals or clutch pedal if incorrect
measurement is found.
(See Adjusting the brake pedal on page 110)
Proper brake pedal free travel
15 mm to 20 mm (0.6 in. to
0.8 in.) on brake pedal.
Keep the free travel in the right
and left brake pedals equal.
13. Checking the gauges, the
meters, and the Easy Checker
™
1. Inspect the instrument panel for broken gauge(s),
meter(s), and Easy Checker
™
.
2. Replace the gauge(s), the meter(s), or the Easy
Checker
™
if they are broken.
14. Checking the head light, turn
signal / hazard light, and so on
1. Inspect the lights such as the head light, turn
signal / hazard light, and so on for broken bulbs and
lenses.
2. Replace the lights such as the head light, turn
signal / hazard light, and so on if they broken.
15. Checking the seat belt and the
ROPS
1. Always check condition of the seat belt and the
hardware to attach the ROPS before operating the
tractor.
2. Replace the seat belt or the ROPS if it is damaged.
16. Checking and cleaning the
electrical wiring and battery cables
WARNING
To avoid personal injury or death:
• A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage of
electricity could result in a fire hazard, a dead
battery, or damage to electrical components.
• Replace damaged wires or connections
promptly.
• If a fuse blows soon after replacement, do not
use a larger than recommended fuse or bypass
the fuse system.
• Many wiring connections are protected by
waterproof plugs, therefore plug and unplug
these connections carefully and make sure that
they are sealed correctly after assembly.
• Accumulation of dust, chaff, or spilled fuel
deposits around the battery, electrical wiring,
engine, or exhaust system are a fire hazard.
Clean around the battery, electrical wiring,
engine, and exhaust system before starting
work.
To avoid premature electrical malfunctions do
not apply high pressure water directly to
battery,
wiring, connectors, electrical
components, or instrument panel.
Inspect the following regularly
• Check the wiring for chafed or cracked insulation.
• Check the wiring-harness-clamps.
Replace wiring-harness-clamps if it is necessary.
• Check the connectors and the terminals for
looseness, contamination, or overheated
(discolored) connections.
• Check the instrument panel for correct operation of
switches and gauges.
Consult your KUBOTA dealer regarding maintenance,
diagnosis, and repair.
17. Checking the movable parts
1. If any of the movable parts, such as levers and
pedals, is not smoothly moved because of rust or
sticky material, remove the rust or the sticky
material, and apply oil or grease on the relevant
spot.
Do not force the movable parts into motion.
Otherwise, the machine may get damaged.
PERIODIC SERVICE DAILY CHECK
104
L4701