Kubota KX057-4, Руководство оператора

Страница: 101 / 134

79 REGULAR CHECKS AND MAINTENANCE WORK
4. Let the engine idle for approx. 5 min. Check the engine
oil level. To check the engine oil level, insert the
engine oil dipstick completely into the respective port
opening and pull out again. If the oil level lies between
both markings, no oil must be added.
A
Regardless of the service hours, an engine oil change
is due every 1 year.
B
Replacing Engine Oil Filter
1. Replace the oil filter cartridge at the same time as
doing the engine oil change.
2. Remove the cartridge with the supplied filter wrench.
3. Oil the O-ring of the new oil filter cartridge lightly. Then
tighten the oil filter cartridge by hand.
4. Fill engine oil to the specified level.
5. Let the engine run for approx. 5 min. and make sure
that the engine oil indicator lamp does not light up.
Then stop the engine and remove the key.
6. The engine oil level is reduced by the amount of the
filter capacity after the engine is started. It is necessary
to add oil.
A
Always check the oil level after having exchanged the
filter.
EVERY 500 SERVICE HOURS
Do all 50, 100 and 250 hour servicing at the same time.
B
Drive unit Oil Change(First Oil Change of
the 50 hours)
To avoid personal injury:
A
Lower to the ground, stop the engine and
remove the key before undertaking the oil
change.
1. Rotate the track so that the drain plug of the drive unit
is in the bottom position.
2. Remove the drain plug to let the oil run out. Screw in
and tighten the drain plug again and fill with gear oil
through the oil check port.
3. Fill oil until it overflows out of the oil check port.
Oil change
- first oil change after 50 hrs
- then every 500 hrs
- or at least once a year
4. Use prescribed gear oil SAE 90.
Engine oil volumes
(with engine oil filter)
9.0 L
(1) Oil filter
(1) Oil check port
(2) Drain plug
(3) Oil filling port
Gear oil volume approx. 0.9 L