Kubota K008-5, Руководство по эксплуатации

Страница: 148 / 168

146
W9215-8135-1
06/2021
Maintenance
Crawler tension - check

The crawler seam (1) is half way between the idler and sprocket.

Check the crawler sag as shown in the figure.
Crawler sag "A" 10-15 mm

If the crawler sag is more than 15 mm, adjust the crawler.

If necessary, tighten or loosen the crawler.

Start the engine and rotate the lifted crawler briefly.

Recheck the crawler tension, readjusting it if necessary.

Perform the procedures on the second crawler.
Crawler tension - adjust
Tightening the crawlers

Position the grease gun on the grease nipple (1).

Pump the grease gun until the specified crawler tension is ob-
tained.
If the crawlers are too tight, wear is increased.
If the crawlers are too loose, wear is increased and the crawlers may come off.
Caution: The area around the rotating crawler must be free of persons. Turn the starter switch to the
STOP position after turning and remove the key.
STOP