Kubota K008-5, Руководство по эксплуатации

Страница: 140 / 168

138
W9215-8135-1
06/2021
Maintenance
The internal filter element must only be replaced by skilled personnel in the framework of the corresponding ser-
vice period.

Clean the outer filter element with compressed air (max. 5 bar)
from the inside out without damaging the filter element. Wear
eye protection for this service.

Insert an outer filter element.

Install the cover with the TOP mark so that the mark is turned
5° (K008-5) or 35° (U10-5) to the left.

Then lock the braces.

Close the engine compartment cover and secure it with a pad-
lock.
Replacing the fuel filter

Open the engine hood (page 112).

Set the cock (1) horizontal to the "C" position.

Remove the filter cup retainer (4) while holding the filter cup (3).

Remove the filter cup and filter.

Clean the filter cup with clean diesel fuel.

Replace the fuel filter (2) and the sealing rings (1).

Apply a light coat of diesel fuel onto the sealing rings.

Assemble the components in the order shown in the figure
above. Tighten the filter cup retainer (4) by hand. Do not use a
tool.

Set the cock vertical to the "O" position.

Bleed the fuel system (page 109). Check the water separator
for leaks at the same time.

Close the engine hood and secure it with a padlock.
Do not clean the filter element with fluids. Never operate the engine without the air filter elements.
Always wear eye protection when working with compressed air.
Place a cleaning cloth under the fuel filter to prevent
fuel from spilling on the ground.
STOP
STOP
1