Kubota GL11000-CAN, Руководство оператора

Страница: 40 / 55

23 PERIODIC SERVICE
ENGLISH
B Replacing the Oil Filter Cartridge
To avoid personal injury:
A
Be sure to stop the engine before changing the
oil filter cartridge.
A
Allow engine to cool down sufficiently. Oil can
be hot and cause burns.
1. Replace the oil filter cartridge every 200 hours of
operation.
2. Remove the old oil filter cartridge with a filter wrench.
Dispose of filter properly.
3. Apply a film of oil to the gasket of the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge firmly
only by hand. If you tighten the cartridge with a
wrench, it will be tightened too much.
5. After the new cartridge has been replaced, the engine
oil level normally decreases a little. Therefore run the
engine for a while and check for oil leaks through the
seal before checking the engine oil level. Add oil if
necessary.
A Completely wipe off any oil sticking to the machine in
the filter area.
AIR CLEANER
To avoid personal injury:
A
Be sure to stop the engine before cleaning air
filter element.
A Make sure hooking clip is tight enough. If it is loose,
dust and dirt may be sucked into the engine, causing
excessive wear or premature engine failure and need
for engine repair.
B
Cleaning Secondary Air Filter Element
Since the air cleaner employed on this engine is a dry
type, never apply oil to it.
1. Open the evacuator valve once a week under ordinary
conditions - or daily when used in severe or dusty
conditions. This will get rid of large particles of dust
and dirt.
2. Wipe the inside air cleaner clean with cloth if it is dirty
or wet.
3. Avoid touching the element except when cleaning.
4. When dry dust adheres to the element, blow
compressed air from the inside turning the element.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm , 30 psi).
5. When carbon or oil adheres to the element, soak the
element in detergent for 15 minutes, then wash it
several times in water, rinse with clean water and dry
it naturally.
6. After the element is fully dried, inspect the inside of the
element with a light, and check if it is damaged or not.
(referring to the instructions on the label attached to
the element.)
7. Replace the primary element every year or every 6
cleanings. If the primary element is heavily stained,
replace it sooner. At this time, also replace the
secondary element.
8. The secondary element should be removed only if it is
to be replaced.
9. To protect the engine, do not remove the secondary
element in normal servicing of the primary element.
(1) Oil filter cartridge
(2) Remove with a filter wrench
(Tighten with your hand)