Kubota D1803-CR-E4, Руководство по ремонту

Страница: 27 / 309

3. Grease the seal lip and dust lip.
NOTE
• If the seal has a dust lip, grease the gap
between the lips.
• After oil seals are replaced, grease the
moving parts around the lip to prevent the
dry surfaces from wearing against each
other during engine start up.
7. Handling the battery
CAUTION
• When removing battery cables, disconnect
negative (-) terminal first.
• When installing battery cables, connect positive
(+) terminal first.
(1) Battery negative (-) terminal (2) Battery positive (+) terminal
• Do not install any battery with a capacity (Ah) other
than is specified.
• Securely attach the terminal covers on the cables
when connecting the cables to the battery terminal
posts. There is a danger of short-circuiting if the tip
of the cables attached to the battery terminal post is
exposed.
• Do not allow dirt and dust to collect on the battery.
• Apply grease thinly to the battery terminal posts to
prevent corrosion.
8. Handling electrical wiring
CAUTION
• Do not put an unprotected electrical wiring to
come in contact with other components.
• Do not clamp the electrical wiring to fuel hoses.
• If the electrical wiring is damaged, repair it with
an insulating tape or rat-proof tape, or replace
the wiring with a new one.
• Do not alter the electrical device and wiring.
• Tighten the electrical terminals securely.
(A) Correct (B) Incorrect: loose bolt
• Check the electrical terminal protection and
clamping conditions before connecting the battery
cable.
(1) Covered completely with a
protection cover
• Keep the wiring away from hazardous positions
such as rotating parts or high-temperature sections.
(2) Hazardous position
(3) Wiring position: poor
(4) Wiring position: good (5) Hazardous position
• Repair or replace damaged or old wiring
immediately.
GENERAL WORKING PRECAUTIONS
7. Handling the battery 2. GENERAL
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
2-3
KiSC issued 12, 2018 A