Kubota CTL SVL97-2, Руководство оператора

Страница: 64 / 158

1. Starting the engine
CAUTION
To avoid personal injury:
• The operator should not depend solely on the
warning lights, but should always conduct the
routine checks section.
(See MAINTENANCE INTERVALS on page 88)
IMPORTANT :
• The starter motor consumes large current.
Avoid running it longer than 10 seconds
continuously.
If the engine fails to start within 10 seconds,
follow the following procedure.
1. Once set the key to the [STOP] position.
2. Wait for 20 seconds or longer.
3. Repeat the following step 2. through step 5..
• If the battery is dead and must be connected to
another battery with jumper cable, be sure to
use a 12 V battery. Never use any 24 V batteries.
• To protect the machine, the machine is
equipped with engine rpm limit control.
When the engine rpm is limited, the master
warning light starts blinking. If the engine rpm
fails to rise enough after warm up, operate the
machine to help the engine to warm up more.
Before starting the engine, make sure that the armrests
are in the raised position, the control levers are in their
neutral position, and the seat belt is fastened correctly.
(1) Left control (traveling) lever
(2) Right (front operating) lever (3) Armrest
Start the engine in the following manner:
1. Set the engine-speed-control-dial to 1/2 position
and keep the accelerator pedal free.
(1) Engine speed control dial (2) Accelerator pedal
2. Insert the key into the starter switch and turn it to
the [RUN] position.
(1) Starter switch (A) STOP
(B) RUN
(C) START
The glow-plug-indicator will light up while the
engine is preheated and will go out automatically
after preheating is finished.
3. Make sure that the and marks appear on
the instrument panel.
If not, the system is malfunctioned. Contact your
local KUBOTA dealer.
(1) Engine oil pressure indicator (2) Battery charge warning light
OPERATION OPERATION OF THE ENGINE
58
SVL97-2