Kubota CTL SVL97-2, Руководство оператора

Страница: 126 / 158

2. Open the drain plug on the bottom of the radiator
and drain coolant completely. if a recovery tank is
equipped, disconnect the line from the tank floor
and then open the drain shutoff-valve.
3. To clean, rinse the radiator with water.
4. Close the drain plug and fill the radiator and the
recovery tank with coolant fluid.
5. Let the engine idle for about five min..
6. Stop the engine and remove the key.
7. Check the coolant level of recovery tank and add
the coolant if necessary.
The machine has been shipped filled with 50%
antifreeze solution.
(1) Drain plug
(2) Radiator cap
(3) Recovery tank (A) FULL
(B) LOW
Cooling water
Radiator
Open cab 12.5 L (3.3 US gal.)
Closed cab 13 L (3.4 US gal.)
Recovery tank 1 L (0.3 US gal.)
IMPORTANT :
• Do not operate the engine without coolant.
• To fill the radiator system and the recovery
tank, use fresh water and antifreeze fluid.
• When the antifreeze is mixed with water, the
antifreeze mixing ratio must be less than
50%.
• Tighten the radiator cap properly. If the cap
is loosely or not properly fitted, overheating
of the engine can result due to coolant fluid
loss.
3. Replacing the fuel hose
1. Replace the hoses and clamps according to
Checking the fuel line and the intake air line on
page 107.
(1) Fuel lines (2) Fuel drain line
MAINTENANCE BIENNIAL SERVICING
120
SVL97-2