Kubota CTL SVL97-2, Руководство оператора

Страница: 121 / 158

8. Retighten the drain plug.
(1) Breather filter
(2) Bolt
(3) Cover
(4) Set bolt (5) Return filter
(6) Filter stopper
(7) Suction filter
9. Fill the hydraulic oil through the oil-filling-plug
opening on the top side of the tank pipe.
10. Remove the plug off the top of the LS pump to pour
oil into it.
Make sure the oil level is as specified, close the
pump top and tighten up the plug. Damage to the
LS pump is possible if this step is not completed
correctly.
(1) Plug
11. Let the engine run, and operate the lift arm and the
bucket.
12. Then lower the lift arms slowly to the ground, and
stop the engine.
13. Fill the hydraulic oil again up to the center of the
gauge.
Hydraulic oil volumes
Hydraulic tank
38.1 L
(10.1 US gal)
Whole oil volumes
68.0 L
(18.0 US gal)
14. Tighten the oil-filling-plug.
2. Hydraulic oil check with the
hydraulic hammers
Changing the hydraulic oil after 1000 operating hours in
the operator's manual is based on normal work. The
following inspection measures are valid when using the
hydraulic hammers.
• Changing and filling up of the hydraulic oil
– Change the hydraulic oil more often when using
the hydraulic hammers because the machine is
subject to harder conditions than normal work.
– Use only the recommended hydraulic oils that
are mentioned in the operator's manual when
changing or filling with the hydraulic oil.
– When adding the hydraulic oil, do not mix oils of
different makes
• Changing the return filter and the hydraulic oil
– Change the return filter more often because of
contamination resulting from the frequent
assembly and disassembly of the hoses.
– Use the correct replacement filter.
– Change oil according to operating hours.
Hydraulic oil Return filter Suction filter
Normal work every 1000 Hrs.
every 500 Hrs.
(250 Hrs. after
first operation)
every 1000 Hrs.
Hammer
work por-
tion
20% every 800 Hrs.
every 300 Hrs.
40% every 400 Hrs.
60% every 300 Hrs.
every 100 Hrs.
more every 200 Hrs.
3. Adjusting the engine valve
clearance
Consult your local KUBOTA dealer for adjusting the
engine valve clearance.
4. Replacing the front window roller
[Closed cab model only]
Consult your local KUBOTA dealer for replacing the
front window roller.
EVERY 1500 SERVICE HOURS
Carry out all 50, 100, 250, and 500 hour servicing at
the same time.
1. Checking the injector tip
Consult your local KUBOTA dealer for checking the
injector tip.
EVERY 1000 SERVICE HOURS MAINTENANCE
SVL97-2
115