Kubota BX1880, Руководство оператора

Страница: 96 / 114

Oil capacity with filter
BX1880
3.0 L
(3.2 U.S.qts.)
BX2380
3.3 L
(3.5 U.S.qts.)
BX2680
4.0 L
(4.2 U.S.qts.)
1. To drain the used engine oil, remove the drain plug
at the bottom of the engine, and drain the engine oil
completely into the oil pan.
(1) Drain plug
2. After draining the used engine oil, reinstall the drain
plug.
3. Fill the engine with the new engine oil up to the
upper notch on the dipstick.
(See LUBRICANTS, FUEL, AND COOLANT on
page 76)
BX1880 and BX2380
BX2680
(1) Oil inlet
(2) Dipstick (A) Oil level is acceptable within
this range
4. Properly dispose of the used engine oil.
3. Replacing the HST oil filter
WARNING
To avoid serious injury or death:
• Be sure to stop the engine before changing the
HST oil filter.
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
1. Remove the HST oil filter.
(1) HST oil filter
2. Put a film of clean transmission oil on rubber seal of
new HST oil filter.
3. Tighten the HST oil filter quickly until it contacts the
mounting surface.
4. Tighten the HST oil filter by hand an additional 1/2
turn only.
PERIODIC SERVICE SERVICE EVERY 200 HOURS
92
BX1880,BX2380,BX2680