Kubota BX1870, Руководство оператора

Страница: 80 / 93

PERIODIC SERVICE 62
B
Replacing Transmission Oil Filter
To avoid personal injury:
A
Be sure to stop the engine before changing the
oil filter cartridge.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean transmission oil on rubber seal of
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the
transmission fluid level will decrease a little. Make sure
that the transmission fluid does not leak through the
seal, and check the fluid level.
Check the dipstick and refill with oil to prescribed level.
5. Properly dispose of used oil.
A
To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
B
Checking Radiator Hoses and Clamps
To avoid personal injury:
A
Be sure to stop the engine and remove the key
before checking radiator hose and clamps.
Check to see if radiator hoses are properly secured every
200 hours of operation or six months, whichever comes
first.
1. If hose clamps are loose or water leaks, tighten clamps
securely.
2. Replace hoses and tighten hose clamps securely, if
radiator hoses are swollen, hardened or cracked.
3. Properly dispose of used coolant.
Replace hoses and hose clamps every 2 years or earlier
if checked and found that hoses are swollen, hardened or
cracked.
C
Precaution at Overheating
Take the following actions in the event the coolant
temperature be nearly or more than the boiling point, what
is called "Overheating"
1. Stop the machine operation in a safe place and keep
the engine unloaded idling.
2. Don't stop the engine suddenly, but stop it after about
5 minutes of unloaded idling.
3. Keep yourself well away from the machine for further
10 minutes or while the steam blown out.
4. Checking that there is no danger such as burn, get rid
of the causes of overheating according to the manual,
see "TROUBLESHOOTING" section, and then, start
again the engine.
(1) Filter
(1) Radiator hoses (2 pcs)
(2) Hose clamps (4 pcs)